...
Make sure your Merging device(s) is running in Multi Interface / ST2022-7 Mode (see Anubis SPS Settings or Hapi MkII Advanced page).
Configure the device(s) IP addresses (the 2 networks should be in different IP ranges)
A device reboot is required to activate the ST2022-7 mode and after any change to the IP addresses.Start the VS3 Control Panel in Administrator mode.
The Primary Network adapter should be already filled in.Add a Secondary Network adapter NIC and press Apply.
To easily differentiate the MassCore NIC cards, you may plug / unplug their network cables.
The connection status will be reflected in the VS3 Control Panel a few seconds after plugging / unplugging the cable
Press OK to close the VS3 Control Panel.
Configure the MassCore NIC IP addresses in Windows, according to the addresses set in the device(s).
Start Pyramix / Ovation MassCore
You can now connect your MassCore and the device(s) in ST2022-7 mode.
Must have both network connected for MSC to start