Content Comparison

...

• Make sure your Merging device(s) is running in Multi Interface / ST2022-7 Mode (see Anubis SPS Settings or Hapi MkII Advanced page).
  Configure the device(s) IP addresses (the 2 networks should be in different IP ranges)
  A device reboot is required to activate the ST2022-7 mode and after any change to the IP addresses.
  Décrire procedure => passe en multiinterface - reboot - vérifier que pas 2 x 169.254 - mettre une adresse si nécessaire - reboot
  

• Start the VS3 Control Panel in Administrator mode.
  The Primary Network adapter should be already filled in.

• Add a Secondary Network adapter NIC and press Apply.

• To easily differentiate the MassCore NIC cards, you may plug / unplug their network cables.
  The connection status will be reflected in the VS3 Control Panel a few seconds after plugging / unplugging the cable
  

  

• Press OK to close the VS3 Control Panel.

• Configure the MassCore NIC IP addresses in Windows, according to the addresses set in the device(s).

• Start Pyramix / Ovation MassCore

• You can now connect your MassCore and the device(s) in ST2022-7 mode.

...