Table of Contents
...
- Enable Expert Mode (Settings>Music)
- In the Setting>Mixer under CUE-4 and CUE-5 unlink the Pan's for those two cues.
- Exit your Settings
- Enter CUE-4 and Pan Anubis Input 1 hard left and Anubis Input 2 hard right left
- Enter CUE-5 and Pan Anubis Input 3 hard left and Anubis Input 4 hard right left
Note: It is preferred to leave all levels to 0dB nominal. - In the MAD or VAD panel Re-UNITE your Anubis and make sure the "Bus Returns" is checked
- Record in your DAW the CUE-4 (Anubis inputs 1-2) and CUE-5 (Anubis inputs 3-4)
Those will be recorded Post FX.
...
Can a Hapi or Horus module be available for 2 different Anubis to monitor, output and mix in low latency?
As of firmware v1.2.2 build 47903 and above two Anubis can peer the same input module. Meaning that the AD1 of the Hapi could be peered by the Anubis-A and the Anubis-B at the same time.
But its important to know that an output module cannot be peered by two different Anubis. So the Anubis- A cannot peer the Hapi Headphones while the Anubis -B also peers the same Hapi Headphones, in this case the last one peering the output module will take over this one.
...