HORUS - HAPI Ex-factory update reset - Shutdown your Horus / Hapi by pressing and holding the triangle power button.
- Press the power button while also pressing and holding the small triangle button to start in Maintenance Mode.
- Once the maintenance mode is ready, please update your device through your web browser with this special firmware :
For Horus
For Hapi
Note : the update with this special firmware will only take a few seconds. - Once done, reboot your device.
HAPI MKII Ex-factory update reset - Shutdown your Hapi by pressing and holding the triangle power button.
- Press and hold the rotary controller on the front panel button, and press on the triangle button to start the unit in Maintenance Mode.
 - Once the maintenance mode is ready, please update your device through your web browser with this special firmware :
For Hapi MKII
Note : the update with this special firmware will only take a few seconds. - Once done, reboot your device.
ANUBIS Ex-factory update reset
| Panel |
|---|
As of Firmware 1.4.0 - Run a Firmware version 1.4.0 and above
- Shutdown the ANUBIS
- Hold Press 2 buttons: The Anubis MUTE button and TALK Button Simultaneously
- Power up the Anubis while holding those two buttons pressed until Anubis powers up completely
This will have reset the Anubis to Ex-Factory while keeping your Mission Presets or Snapshots |
Legacy: With firmware 1.2.6 and prior - Open the Anubis Maintenance Page (Gooogle Chrome recommended)
- Download and update the file below as if it was a firmware update.
Anubis factory Reset update:
https://betadownload.merging.com/ExternalLinks/Anubis/FactoryReset/ResetConfigToFactory.Anubis
- Once updated, reboot Anubis
Let us know if it solves the problem
|