...
- Set bridge channels in the MAD panel
Open the Merging Audio Device panel, and set the required number of Bridge channels (sampling rate dependent).
Please note that even if you don't use all the bridge channels you have set, it will use some CPU processing.
Therefore it is recommended to only set the number of channels you need.
Note on Master ASIO Host : you may also set now a Master ASIO host, that will be the sampling rate master.
If you rather want to set the sampling rate from the MAD panel, set the Master ASIO Host to Merging Audio Device. - ASIO DAW setups
In this example we will route audio from Reaper into Pyramix, but the same procedure applies to any ASIO DAW.
Start your primary ASIO DAW (Pyramix) and create / open a project.
Add strip(s), depending on how many channels you need from the secondary ASIO host.
Select the required MAD Bridge inputs (and set the "bridged" strips to Rec Ready / Input to monitor it)
Now start your secondary ASIO DAW
Configure it to have its output routed into MAD Bridge outputs.
See the example with Reaper.
You can also send the audio from the primary ASIO DAW into the secondary one, but please take care about the routing to avoid feedback.
...