...
For each devices, enter a Device Name (1), and set the IP addressing mode (2)
Note :
- The device name have to be unique in a network.
Go to System (1) tab and Reboot (2) the devices to apply IP and Naming
Now let's create the AoIP transmitters which have to done for all the Anubis separately.
For each Anubis to be configure, launch the advanced web page by using MT Discovery. Click on Session source (1) tab and click on (2) to create a new transmitter (Session source).
Once created, name it.
Note: if receivers created above match the name of the transmitter, the audio stream becomes effective.
Transmitter name should be carefully chosen specially when many streams have to be setup. A good practice is to prefix the stream with the Anubis role. This ensure a proper way listing all the available Transmitter when sorted in an alphabetic order.
Choose which codec you want to use.
Note: L24 is the default and recommended codec. L32 may be not be compatible with some receiver.
Scroll down and choose the channel count of the stream (1), and apply (2).
Note: channel count on transmitter and receiver side have to match otherwise the receiver will tell you that channels count to not match
Patch the stream to an available inputs. Inputs may be a physical audio input or a monitor mix.
Here is a second transmitter name "V1 Heaphone loopback" created and patched to Heaphone 1 mix.
Note: This is handy when the sound enginneer, want to check the performer mix.
...
- The device name can be changed from Dante controller