| Table of Contents | ||
|---|---|---|
|
...
Anubis SPS (Pro or Premium) “Made in Hungary”
For Serials numbers below 10000* a hardware modification is required, which can be installed by our Servicing for a fee.On the Anubis made in Hungary the Serial Number is under the unit and located in the last 6 digits
In this example, Anubis serial number is 001580, so below 10000* and not Dante Ready, but eligible to a future Upgrade plan that we will communicate shortly.
...
*The same applies to the Neumann MT 48.
Anubis SPS (Pro or Premium) “Made in Switzerland”
Serial numbers A61XXXX or A66XXXX a hardware modification is required, which can be installed by our Servicing for a fee.
...
Those settings (Master-Leader, Slave-Follower, External Sync, latency, …) can be accessed with the Dante Controller. Some other settings, like Peering, NMOS,…do not apply to Dante Networks, and are therefore removed.
Are the interfaces supporting Dante in 32bit?
Hapi MkIII, Anubis and MT 48 latest generations fully support Dante 32bit AoIP.
(32bit integer, not to confuse with 32bit Float)
How to I remote control and manage my Anubis or Hapi MkIII Dante interface?
We recommend installing the MTDiscovery 15.0.10 and above and MT Portal 1.2 and above application. Those applications will allow the firmware and software updates along with Remote Control and Web Access control acess of your unit.
Note: The Merging ANEMAN, MAD and VAD are for RAVENNA/AES67 and do not support Dante mode.