Table of Contents
...
With the Anubis Music Mission current version, the recordings of the Anubis inputs channels into your DAW or application by default are non-destructive (no Anubis effect will be applied). The record back post-processing of the Anubis strips is not implemented, but there are ways to solve this since users can record back the Anubis outputs. Meaning a strip channel can be sent to Cue or Mix and recorded back post Effect into your DAW.
Enable the "Bus Returns" option in the UNITE dialog in order to do so or follow the example below.Example: Record back all Anubis 4 x Inputs post-processingfeasibility to record Post- FX signal (Post-Effect) is avialable. This one includes the EQ and Dynamics plugins. Record the Physical Input Direct signal (Pre-Effects) and the Post-FX single independently or simultaneously. Support for Unite Post-FX is requiring the VAD 3.2.1 and higher or MAD 2.2.0 and higher version along with an Anubis Firmware 1.4.2 and above.
In the UNITE dialog Post-FX Inputs should be checked
Users can connect the Post -FX channels via ANEMAN.
The Reverb, the Parallel Dynamics and Sends are not in the Strip signal Effect path. In order to record those, it is recommended to record the Bus returns.
To record Bus Returns (Reverd, Parallel Dynamics and other applied Effects) the Cues can be used. Procedure below.
- Enable Expert Mode (Settings>Music)
- In the Setting>Mixer under CUE-4 and CUE-5 unlink the Pan's for those two cues.
- Exit your Settings
- Enter CUE-4 and Pan Anubis Input 1 hard left and Anubis Input 2 hard right left
- Enter CUE-5 and Pan Anubis Input 3 hard left and Anubis Input 4 hard right left
Note: It is preferred to leave all levels to 0dB nominal. - In the MAD or VAD panel Re-UNITE your Anubis and make sure the "Bus Returns" is checked
- Record in your DAW the CUE-4 (Anubis inputs 1-2) and CUE-5 (Anubis inputs 3-4)
Those will be recorded Post FX.
...
How many EQ and Dynamics can I use with the Music Mission ?
21 56 x EQ of 4 bands each are available (as of Firmware 1.4.6 and above)
64 x Dynamics are available within a single Anubis running the Music Mission.
4 to 20 Merging+Deesser depending of EQ and Dynamics resources available
1 x Merging+Reverb
1 x Eventide Blackhole
Can we EQ only the Dynamics and Reverb FX signal ?
...
Can a Hapi or Horus module be available for 2 different Anubis to monitor, output and mix in low latency?
As of firmware v1.2.2 build 47903 and above two Anubis can peer the same input module. Meaning that the AD1 of the Hapi could be peered by the Anubis-A and the Anubis-B at the same time.
But its important to know that an output module cannot be peered by two different Anubis. So the Anubis- A cannot peer the Hapi Headphones while the Anubis -B also peers the same Hapi Headphones, in this case the last one peering the output module will take over this one.
...