Dante Setup Guidelines
Detailed procedure on how to setup the Anubis or Hapi MkIII for Dante AoIP operation mode.
Warning: A Dante license must be purchased separately.
Requirements:
A Hapi MkIII / Anubis
The Hapi MkIII / Anubis Dante Firmware
Applications installed (MT Discovery, MT Portal and Dante Controller)
Creation of an Audinate account
License purchasing plan is an additional cost
Procedure:
Download and Install the Merging MT Discovery application and MT Portal.
Those can be downloaded from the Merging website or Neumann website.Connect the Hapi MkIII /Anubis via a gigabit network to your system
Launch the MT Portal application, select your device and select the Dante tab.
The MT Portal will display the Dante firmware, please click on Download & Update.
Note: The firmware update will take more than 15min, please do not abort at anytime.
The MT Discovery application can also be used to update the Firmware manually.
Once the Hapi MkIII/Anubis is detected, please right click on the required device and Open the Maintenance Page.
Select and update the Dante firmware that was previously downloaded from the Merging site.
Once the Dante Firmware has been updated, please reboot the unit.
Make sure you have downloaded and installed the Dante Controller application from the Audinate website.
The Dante Virtual Sound Card (ASIO/CoreAudio driver) is also recommend for operating your DAW in Dante mode (see additional information below)With the Hapi MkIII/Anubis connected to the system running Dante Controller launch the Dante Activator from the View menu.
Alternatively, the Dante Activator will also notify that Devices are available for activation, in the Dante Controller icons.
The Hapi MkIII/Anubis should be detected into the Dante Activator
Select the Hapi or Anubis device and choose a license plan.
Anubis: 8 x 8 IO or 64 x 64 IO are available
Hapi MkIII: 16 x 16 IO or 64 x 64 IO are available
Note: License plans are upgradable and current paid amount will be deducted from the upgrade cost.
Go to Cart and Check out
You will be asked to Login on your Audinate account, create one if you don’t already have one.
Activate your license plan upon entering the purchase details (e.g. credit card)
Wait for the confirmation of the Activation.
The Hapi MkIII/Anubis is now ready for Dante operations.
It will be discovered into the Dante Controller and can be used with other Dante devices or the Dante Virtual Sound Card. (Dante Virtual Sound card and/or Dante VIA must be purchased separately from Audinate)
Additional Information
Dante Virtual Sound card and/or Dante VIA must be purchased separately from Audinate
The Dante Virtual Sound Card IO channel count support differs.
Refer to Audinate DVS documentation for details.