SetUp

You may assign several outputs to the Monitor channels, allowing to duplicate the same signal on several outputs.
Note : Each channel output may have its own EQ, but the volume control is global.

Prerequisites

Anubis Monitoring Mission - running Firmware 1.4.10 (or above).
If you need to use a peered device, such device have to run the same firmware generation as the Anubis.

Procedure

Go in the Anubis Settings > Monitors, and select the required Monitor (or create and configure a new one).
Scroll down to the Patches section
Press on the first channel patch.
The patch list will show you all available outputs; in this example, we will use a peered Hapi MKII.
Press the Add button on the required output
The additional output will now be displayed below the primary one.
Repeat the same operation for each Monitor channel.

You have duplicated the Monitor out on several outputs.

Browser not supported