Configure the default built-in Talkback in order to communicate to a Monitor

The Built-in Mic is by factory default assigned to the Talks channel 1.
But this Talk 1 is not assigned to Monitors (to avoid feedback).
In this example we will setup the Talk1 on Headphones 1 Monitor set.

Prerequisites:

  • Headphones connected to the Anubis physical Phone 1.
  • Built-in Mic  is patched in Talk 1 (factory default).


Assign the Talkback to the Phone 1 Monitor

  1. Enter the Anubis Home Page, then access the Settings.
  2. Go in the Monitors menu
  3. Select the Phone 1 monitor set.
  4. Browse to the Talkback section
  5. On Talk A, press the select Talk 1

The built-in Mic is now the Talkback for the Phone 1 Set.



Talkback with Anubis to a Merging Hapi or Horus output set.

If you wish to have Anubis Talkback built-in injected into a Hapi or Horus output, the procedure will require that you.

  1. Create a Monitor in Anubis and select CUE Type 
  2. Enable the Talkback into that Monitor (bottom settings option e.g. Talk A)
  3. Make sure that your Triggers setting have the correct Talk routing.
  4.  Select the Anubis CUE, open ANEMAN and connect this one to the Output channels of your Hapi or Horus.
    Typically connect the CUE to the Hapi or Horus Headphones.
  5. Now when enabling the Anubis Talkback button the Talk will be injected into the Hapi ou Horus Headphones.