Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. With the device IP address (Anubis / Hapi MKII / MT48)
    In your browser, enter the device IP address followed by /advanced/index.html
    E.g: 169.254.80.179/advanced/index.html
  2. Through MT Discovery :
    Right click on your Merging Dante ZMAN device and select Open Advanced.


Dante Controller

Sample rate and network configuration can also be accessed with Dante Controller.
Some settings (device latency, audio codec,....) can only be accessed with Dante Controller.


GENERAL SETTINGS

 

Device Name

...

  • Sample Rate : current sample rate (44100-48000- 88200-96000-176400-192000)
    This setting can be modified with Dante Controller.

Network

  • Redundant mode : Activate / deactivate Redundant mode - only applicable to Merging devices supporting such feature.
    A reboot is required for the change to apply.
    This setting can be modified with Dante Controller.

Interface 1-2

Note : depending on the device, only Interface 1 might be available.

  • Link : status
  • Name : information only - can't be modified
  • Type : defines the type of IP V4 address used (Zeroconf - DHCP - Static)
  • Address - NetMask - Gateway - DNS : only available if Type is set to Static.
    Reboot is required for changes to apply.
    Those settings can be modified with Dante Controller.


INS/OUTS

Allows to change the name of module's specific Inputs and / or Outputs. (when applicable)




...

      • Anubis and MT48 displays their Device Name on TFT and flashes Home button.
      • HapiMkII flashes its front panel Merging logo.


Appendix

  • Dante mode is only available for Merging Technologies Anubis and Hapi MKII, and Neumann MT 48.
    Previous Merging devices, Horus and Hapi, are not compatible.
  • Dante mode requires a Dante license.


https://www.audinate.com/learning/technical-documentation
https://en.wikipedia.org/wiki/Precision_Time_Protocol



...