Versions Compared

Old Version 1

changes.mady.by.user David Jacques

Saved on

compared with

New Version 2

changes.mady.by.user David Jacques

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Info

The MAD - MassCore mode allows you to use use the MAD virtual ASIO driver (including its WDM bridge) to integrate ASIO inputs and outputs in your MassCore system.
The MAD - MassCore mode is using the MT ASIO bridge to communicate with the MassCore engine.

Note : 
Running Pyramix / Ovation in MassCore mode requires a MassCore authorization key in addition to the Pyramix / Ovation packs.
Aneman must be downloaded and installed separately from the VAD (Mac) / MAD (PC) driver.  
Limitation :
The naming of the devices modules is only available in Unite mode.
Currently not compatible with DSD sampling rates (please use DXD projects with Hepta SRC)
The inputs and outputs channel count is the same.

Table of Contents


Prerequisites

  • MassCore Pyramix or Ovation installed.
  • Merging Audio device driver v2.0 (or above) installed.
  • MassCore Network Card (NET-MSC-GBEX1)
  • Merging RAVENNA/AES67 device connected to the MassCore card.

Procedure

  1. Start the Merging Audio Device panel.
  2. Select the MASSCORE mode tab and confirm you want to switch the mode.
    Image Added
    Note : The panel will indicate that the Bridge is not initialized and MassCore not running, that is normal.

  3. Click on the Advanced Settings button at the bottom of the UI.
    Image Added

  4. Now the number of channels needs to be set.
    Click on the value next to Inputs or Outputs (in this mode, the number of channels for inputs and outputs is the same.)
    Select the Change... value


  5. This will automatically open the VS3 Control Panel.
    Please make sure that Pyramix or Ovation Platform is set to MassCore.

  6. In the Audio Bridge section at the bottom of the panel, activate the MT ASIO bridge Host.
    Set the required Number of Channels (I/O)
    Press OK to confirm and close the panel.


    Note : the number of channels values will be updated automatically in the MAD panel.
  7. Start your MassCore Pyramix / Ovation.
    The MT ASIO bridge inputs 
  8. ASIO DAW

Start MAD and clickon MSC

Confirm

Open the advanced settings

set number of channels

VS3 activate MT ASIO Bridge and set channels
OKto confirm and close VS3CP

Num of channels will update automatically 

Strta PMX / OV


BRIDGE CHANNELS MSC