Page Comparison

...

• If you are not using a Merging DAW, if you use Avid MicPre protocol to control the preamps, that is normal, as Avid MicPre only works with 3 db Steps.
  Merging has made several improvements, make sure you use firmware v3.0.3b26178 or above.
  In most circumstances it is better to enable the ProTools MicPreamps option "Retain the current Setting" under the Peripherals in order not to loose MIDI Pre communication

  Pro Tools on Mac :
  Horus / Hapi / Anubis analog preamps can be controlled directly from within Avid Pro Tools
  running on a Mac. (using Virtual Audio Device Premium). In order to set Pro Tools up for Horus
  / Hapi / Anubis preamp control follow this procedure:

  1.

  1. Check the Horus / Hapi / Anubis firmware version and update if necessary, to the latest
     version.
     
     

  2. Connect Horus / Hapi / Anubis to the system running Pro Tools through the Ethernet port.
     Within Pro Tools

  3. Launch Pro Tools and configure to work with RAVENNA Core Audio I/O.
     
     

  4. Open Pro Tools Setup>MIDI>Input Devices…

     Image Modified

  5. Enable the Merging RAVENNA interface (Horus, Hapi or Anubis).
     
     

  6. Open Pro Tools>Setup>Peripherals Settings.
     
     

  7. In the Peripherals panel select the Mic Preamps tab:

     Image Modified
  8. Select in order: 
     Image Modified
     
     
  9. Note:
     • For the first AD module Receive From > Channel 1 and Send To Channel 1 must be set (Anubis will
     be as of cannel #9 with latest versions)
     • For the second AD module Receive From > Channel 2 and Send To Channel 2 must be set.
     • For the third AD module Receive From > Channel 3 and Send To Channel 3 must be set.
     • For the fourth AD module Receive From > Channel 4 and Send To Channel 4 must be set
     Warning: Horus and Hapi users must verify the order of their AD modules as the Channel numbering is based
     on slot position. Anubis users will typically receive from Channel 1 to Channel 1
  10. Click on OK to close the Peripherals panel.
      Within Pro Tools
  11. Open the Pro Tools I/O Setup panel:
      Image Added
      
      
  12. In the Mic Preamps tab enable Horus PRE #1 etc. check the boxes to the left of the entries.
      
      
  13. Click on OK to close the I/O Setup panel.
      
      The Horus, Hapi and Anubis Preamp controls will be available within Pro Tools when the Horus
      / Hapi / Anubis Preamps are connected to the Pro Tools Mixer Strip Inputs.

• If you are using Merging DAW, make sure you use the firmware related to your Pyramix version:

...