Here is how to access the Cisco SG300-10 & SG300-20 Switch's Web - Administration page.
| Info | ||
|---|---|---|
| ||
| Please note that this only applies if you are accessing the router for the 1st time. If you load one of our configuration files, the ip address for the admin page is 169.254.1.254 and the default user name and password is cisco If you are doing this without one of our config files then follow this guide. |
- Plug a network cable to the router/switch and to your pccomputer.
Make sure Set your computer haves a to use an IP configuration in the 192.168.1.x network address pool.
Info title Default Network Access config. The Cisco routers/switch's come with a default
confignetwork configuration in that
address pool, so inIP pool.
Default IP: 192.168.1.254
In order for your computerto communicate with
it, it will also require it to be in that same address pool, that can be changed in the
routersthe router/switch you must set your computer to use an IP that is in that IP RANGE.
in.
The router/switch default IP can be changed configuration page once you arelogged into it.
You can find more information about it in the CISCO users manual in PAGE 8Open a navigator page to navigate to: http://192.168.1.254
Info title Access the Administration Page. You can use any navigator to do that, once Once the page loads you will be prompted to
enter the user name and password to login.
Enter the default
HTTP://192.168.1.254Default user name: cisco
Enter the defaultDefault password: cisco
Info title Change default user password. After the login it will prompt, you will be asked to to change that default password to whatever you want.
It is recommended to do so. Enter whatever user name and password you want.
After setting this up, it will probably ask you for a reboot (if it does not, reboot it manually).
After reboot, and you will have to login with the new user name and password you just setup.
a required step and the first one into securing you're router/switch, it is also a one time step only.
After the default is changed, if you wish to change it again it you will have to do that in the Administration page.
Reseting the switch to "factory defaults" that will also ask you to do this step again.
- The Administration page will now load and you cant start configuring your switch.
