Cisco Routers Manual Switch Configuration
- Paulo Tavares
- David Jacques
- Claude Cellier
General Info.
This is in no case an exhaustive configuration procedure, It's a simple guide on how to configure these switches to use them with Ravenna/AES67 networks.
Connecting several Cisco switches together requires additional configuration.
Please also see the Multiple network switches considerations page and Cisco SG300/350 Multiple switches configuration guide.
IMPORTANT NOTE ON IP ADDRESS RANGE :
The Internet Engineering Task Force (IETF) has directed the Internet Assigned Numbers Authority (IANA) to reserve the following IPv4 address ranges for private networks:
192.168.0.0 to 192.168.255.255 / 172.16.0.0 to 172.31.255.255 / 10.0.0.0 to 10.255.255.255.
Private IPs should only be in these ranges (see https://en.wikipedia.org/wiki/Private_network )
Table of contents.
1. Access SG300-10&20 Administration
- Accessing the configuration page.
- Changing the default user password.
- Change Switch IP.
- Change IGMP settings.
- Change Green Ethernet settings.
- Change QoS settlings.
- Adding a VLAN
- Change VLAN IP Address
- Change IGMP settings.
- Change Green Ethernet settings.
- Change QoS settlings.
4. Backup Switch Configuration
- Backup Running Configuration
- Backup Backup Configuration
- Backup Default Configuration
5. Import Switch Configuration.
- Import configuration from a file.
- Save configuration to running config.
- Download latest Firmware
- Install latest Firmware