Page Comparison

By default the QoS settings setup by CISCO are ok for Ravenna AES67, but if you need to change them
for your own needs you can do so in the Quality of Service menu.By default, our config files uses use the Basic QoS Mode settings, as shown in the following pictures but the DSCP to Queue are settings modified.
Please check your current configuration and set them to the same as show in this guide.

1. QoS Mode: Basic MODE
   Image RemovedImage Added  Image Removed
   Image Added
   
   
2. On the QoS Basic Mode / Global settings the Trust Mode should be : DSCP
   Image Added
   
   
3. By default these are the DSCP
   Image Removed
   
4. DSCP to Queue: defaults
   Image Removed

...

1. to Queue settings, we will change that.
   Image Added
2. Change the DSCP to Queue Settings as shown in the following picture and click apply to apply the new settings to the current running configuration :
   Image Added
3. Once you click apply the following appears at the top of the DSCP to Queue window.
   Image Added
   Click on the Copy/Save Configuration link to go directly to the save configuration page.
   
   
4. Save your settings from Running Configuration to Startup Configuration (click apply to save).
   Image Added
   That will then apply the current settings to the start up configuration witch will be run every time the switch reboots.
   In other terms that makes that configuration to become permanent.