| Panel |
|---|
Before Starting Important! If you have problems accessing the switch for configuration when connected to the Merging MassCore PCIe Ethernet card (NET-MSC-GBEX1) please connect it to the PC’s on-board Ethernet port. When configuration is completed reconnect the switch to the MassCore Ethernet card. |
...
- Open the System > DHCP server > DHCP Server Properties
Set the parameters as in the screen shot above.
Click on Apply Changes.
Open the Switch > Ports > Port Configuration page and select Show All:
Set all the Flow Control entries to Disable:
This setting minimizes latency on the RAVENNA Network.
Open the Switch > Ports > Spanning Tree > STP Port Settings page:
Click on Show All
- In the STP Port Table window, check all Fast Link check boxes as shown in the screen shot above.
Note: Please ignore the 4 numeric entries in the Path Cost column and the Port State entries since these are derived from your current connection so these values may vary. - Click on Apply Changes.
- Open the Switch > Ports > Green Ethernet page:
- Set both Link Down Energy Detect Mode and Link Short-Reach Energy Detect Mode to off.
Open the Switch > Multicast Support > Global Parameters page.
- Set both drop-downs to Enable as in the screen shot above.
- Open the Switch > Multicast Support > IGMP Snooping page:
- Configure IGM Snooping as in the screen shot above. Querier IP Address needs to be the fixed IP address of the switch itself.
- Click on Apply Changes.
- Open the Quality of Service > CoS Global Parameters > CoS Settings page:
Configure CoS settings as in the screen shot above.
Click on Apply Changes.
- Open the Quality of Service > DSCP to Queue Mapping page:
Configure DSCP to Queue Mapping as in the screen shot above. (note that some DSCP cannot be modified on the switch)
Click on Apply Changes.
- Log out of the switch which is now configured properly.
...