...
- In order to connect your DAW playback to Anubis you must first have a Source available to host your DAW Playout Stream 1-2 (if stereo) Note: Ex-factory Anubis comes with a DAW 1-2 Source. If this one is not available in the Sources page, create it, refer to this page.
- Launch your DAW making sure it is loading Merging’s Driver (or MassCore for Pyramix users) and then open ANEMAN.
- Within ANEMAN connect the RAVENNA ASIO Driver Output 1-2 (or VAD Outs 1-2) to the DAW Source 1-2.
Users can choose and apply either a Multicast or a Unicast connection.
Unicast: from one source to one destination i.e. One-to-One
Multicast: from one source to multiple destinations stating an interest in receiving the traffic i.e. One-to-Many.
ANEMAN DAW 1-2 Source connection (Open the Matrix view and select both Anubis and the Driver to establish a connection)
Note: If the connection is not successful, make sure that both your Anubis and Driver are at the Same Sampling Rate and Latency Frame mode (e.g. AES67-48 samples).
Mac OS users will only see the connections properly established once the DAW playback is engaged. Patch your Monitor Set. Ex- Factory Speaker Sets: A, B, and Headphones 1, 2 should already be patched to their respective physical outputs.
This can be verified and changed if desired under the Settings>Monitors Patch section.
Default Patching under the respective Sources and Monitors settings
Note: Settings>Monitor Line 3-4 Speaker B should be patched to Patch to Jack 3/4_3 and Jack 3/4_4
Note: The operator is free to change the default patch in order to suit his Monitoring setup- Return to the Main Anubis Source page in order select which source and from which Monitor set you will monitor.
First select the Monitor Set (e.g. Anubis A or B button), then select the DAW 1-2 Source to monitor it. - In order to monitor multiple sources simultaneously enable the SUM option and sum your Sources selections.
To control the Headphones volume, simply select the Headphone 1 button and use the Anubis Rotary knob to adjust its Volume.
Note: The Speakers Set mode and Headphones mode listen to the same Sources selection. In order to listen to different Sources, a Monitoring Cue must be configured (refer to the Settings>Monitors Cue mode section)
Note: To connect mirrored outputs (an input/soirce to Multiple outputs) can be achieved from the RAVENNA Advances paged.
...