Configure the default built-in Talkback in order to communicate to a Monitor
The Built-in Mic is by factory default assigned to the Talks channel 1.
But this Talk 1 is not assigned to Monitors (to avoid feedback).
In this example we will setup the Talk1 on Headphones 1 Monitor set.
Prerequisites:
- Headphones connected to the Anubis physical Phone 1.
- Built-in Mic is patched in Talk 1 (factory default).
Assign the Talkback to the Phone 1 Monitor
- Enter the Anubis Home Page, then access the Settings.
- Go in the Monitors menu
- Select the Phone 1 monitor set.
- Browse to the Talkback section
- On Talk A, press the select Talk 1
The built-in Mic is now the Talkback for the Phone 1 Set.
Talkback with Anubis to a Merging Hapi or Horus output set.
If you wish to have Anubis Talkback built-in injected into a Hapi or Horus output, the procedure will require that you.
- Create a Monitor in Anubis and select CUE Type
- Enable the Talkback into that Monitor (bottom settings option e.g. Talk A)
- Make sure that your Triggers setting have the correct Talk routing.
- Select the Anubis CUE, open ANEMAN and connect this one to the Output channels of your Hapi or Horus.
Typically connect the CUE to the Hapi or Horus Headphones. - Now when enabling the Anubis Talkback button the Talk will be injected into the Hapi ou Horus Headphones.